3.3.2. Check of chains of the switch of blocking of a starter (AKPP selector switch)

Fig. 3.48. Check of chains of the switch of blocking of a starter

Adjustment of the switch of blocking of a starter (AKPP selector switch) and cable of management of AKPP

Fig. 3.49. Adjustment of the switch of blocking of a starter

Establish the AKPP selector lever in the situation "N".

Weaken an adjusting nut of fastening of a cable of management of AKPP to the lever of manual control.

Establish the lever of manual control (manual control lever) in neutral situation («N»).

Fig. 3.50. Bolts of fastening of the switch of blocking of a starter

Weaken bolts of fastening of the switch of blocking of a starter (the AKPP selector switch) and turn its case so that the opening in a flange of the case of the switch was combined with an opening on the end of the lever of manual control (manual control lever, section A-and in drawing 3.50

Without allowing change of position of the switch of blocking of a starter (the AKPP selector switch), tighten bolts of its fastening the nominal moment.

Fig. 3.51. Adjusting nut

Slightly pull a cable connecting the lever of the AKPP selector to the block of operating valves in the direction, specified by an arrow in drawing 3.51, and then tighten an adjusting nut.

Be convinced of that the lever of the AKPP selector is in the situation "N".

Check compliance of included transfers to each position of the lever of the AKPP selector and be convinced that the transmission works normally at each of ranges.