Hyundai Matrix service from 2002 to 2006 of release
	1. Operation and car maintenance
	2. Engine
	3. Transmission
	4. Running gear
	5. Steering mechanism
	6. Brake system
		6.1. General information
			6.1.1. Check and adjustment of a pedal of a brake
			6.1.2. Check of operation of the vacuum amplifier of brakes without a tester
			6.1.3. Air removal from a hydraulic actuator of brakes
			6.1.4. Check and adjustment of a course of the lever of the parking brake
			6.1.5. Removal and installation of the vacuum amplifier of brakes
			6.1.6. Check of highways of brake system
			6.1.7. Removal and installation of a pedal of a brake
			6.1.8. Removal, check and installation of forward brake shoes
			6.1.9. Dismantling, check and assembly of a brake support
			6.1.10. Dismantling, check, assembly and installation of the main brake cylinder
			6.1.11. Regulator of pressure of back brakes
			6.1.12. Removal, check and installation of back drum-type brakes
			6.1.13. Replacement of the working brake cylinder
			6.1.14. Removal, check and installation of the parking brake
			6.1.15. Anti-blocking system of brakes (ABS)
			6.1.16. Removal and installation of the electronic ABS control unit
			6.1.17. Removal and check of sensors of frequency of rotation of a wheel (ABS)
		6.2. Tables
	7. Onboard electric equipment
	8. Body
	9. Electric equipment schemes

6-1-13-zamena-rabochego-tormoznogo-cilindra.html

6.1.13. Replacement of the working brake cylinder

Remove brake shoes.

Disconnect from the cylinder a brake tube.

Fig. 6.51. Bolts of fastening of the wheel brake cylinder

Unscrew two bolts of fastening and remove the wheel brake cylinder (fig. 6.51).

Remove cylinder cuffs.

Remove covers of the piston and the piston.

Fig. 6.52. Returnable spring

Remove a returnable spring (fig. 6.52).

Fig. 6.53. Components of the wheel brake cylinder

Before assembly of the wheel brake cylinder check the details listed below (fig. 6.53).

The cylinder and the piston – on lack of wear and a rust.

The cylinder case – on lack of cracks and other damages.

Condition of a contact surface of the piston and brake shoes.

Condition of a returnable spring.

Assembly and installation of the brake wheel cylinder are made upside-down.

NOTE

Before assembly wash out details isopropyl alcohol.

Before installation grease details with pure brake liquid.

Cover and a piston cuff repeatedly do not establish.

ATTENTION

Be careful, do not lose a steel ball of the drainage union.