Hyundai Matrix service from 2002 to 2006 of release
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
5.1. General information
5.1.1. Technical operations on the car
5.1.2. A steering with the amplifier
5.1.3. Removal, check and installation of a steering column and shaft
5.1.4. Removal and installation of the lock of a steering column
5.1.5. Removal and installation of the driveshaft of a steering
5.1.6. Removal of the steering mechanism
5.1.7. Dismantling, assembly and installation of the steering mechanism
5.1.8. Removal and installation of hoses of hydrosystem of the amplifier of a steering
5.1.9. Removal and installation of a returnable tube and hose
5.1.10. Steering check with the amplifier
5.1.11. Removal, dismantling, check and assembly of the pump of the hydraulic booster of a steering
5.2. Tables
6. Brake system
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 









5-1-8-snyatie-i-ustanovka-shlangov-gidrosistemy-usilitelya-rulevogo-upravleniya.html

5.1.8. Removal and installation of hoses of hydrosystem of the amplifier of a steering

Fig. 5.72. Hoses of hydrosystem of a steering



Removal

Fig. 5.73. Adjusting labels on the union


Combine adjusting labels on the union, a delivery tube and a hose assembled, then put on a delivery hose (fig. 5.73).
Remove an inlet air hose of the engine assembled.
Remove a clamp of a delivery hose of hydrosystem of the amplifier.
Disconnect a delivery tube from the union of the steering mechanism.
Lift the car on the lift and remove a clamp of fastening of returnable and delivery tubes.

Fig. 5.74. Perepuskna bolt of a delivery hose


Lower the car and unscrew perepuskny a bolt (24 mm) delivery hose on the pump of the hydraulic booster of a steering (fig. 5.74).

Fig. 5.75. Delivery hose


Remove a delivery hose and a tube assembled (fig. 5.75).

Installation
Installation of details is made as it should be, the return to removal.

NOTE
At installation of a delivery hose and a tube be assembled convinced that they are not overwound and there is no possibility of their contact to other details of the car.

After completion of installation remove air from hydrosystem of the amplifier of a steering.

«previous page
5.1.7. Dismantling, assembly and installation of the steering mechanism
following page»
5.1.9. Removal and installation of a returnable tube and hose