8.4.5. Removal and installation of a winding of the electromagnetic coupling of the compressor

Remove a nave of the coupling and a pulley.

Establish in compressor boring the adaptation for protection of a shaft.

Establish a pulley on a compressor shaft. Establish an end face of a bolt of a stripper in a concave central part of the adaptation for protection of a shaft, get stripper captures under a winding holder.

Fig. 8.75. Spressovka of a winding

Rotation of a bolt of a stripper press a winding (fig. 8.75).

Clear a landing surface of a holder of a winding.

Establish the compressor in vertical situation and establish a winding on a forward head of the compressor.

Check correctness of position of the socket of a winding of the coupling.

Establish the adaptation for compression on a sock of the compressor and in the winding center.

Establish two 8-inch captures on the compressor and the adaptation for compression. Pads of captures should be deeply got for a forward landing part of the compressor, and the bolt should settle down in the adaptation center for an obzhatiya.

Fig. 8.76. A bolt for a winding napressovka

Rotating a bolt a key, it is reliable напрессуйте a winding on a forward head of the compressor (fig. 8.76).

Establish a pulley and a coupling nave on the compressor.