Hyundai Matrix service from 2002 to 2006 of release
1. Operation and car maintenance
2. Engine
2.1. Maintenance
2.2. Mechanical part (engine of 1,6 l)
2.3. Mechanical part (engine of 1.8 l)
2.4. Cooling system
2.5. Greasing system
2.6. Power supply system
2.7. Control system, fuel system and system of decrease in toxicity
2.7.1. Main malfunctions and their reasons
2.7.2. Check of a technical condition (Check of frequency of rotation of the crankshaft of the engine idling)
2.7.3. Check of operability of the fuel pump
2.7.4. System of compulsory ventilation of a case
2.7.5. Catching system паров fuels
2.7.6. System of supply of fuel
2.7.7. Check of a control system by the engine with the distributed injection
2.7.8. Removal, check and installation of fuel nozzles
2.7.9. System of decrease in toxicity of the fulfilled gases
2.7.10. Removal and installation of the main exhaust silencer
2.7.11. Check of tightness of system of production of the fulfilled gases
2.7.12. Cars with catalytic converter in system of production of the fulfilled gases
2.7.13. Service regulations of cars with catalytic converter in system of production of the fulfilled gases
2.8. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 









2-7-5-sistema-ulavlivaniya-parov-topliva.html

2.7.5. Catching system паров fuels

Fig. 2.222. Scheme of system of catching паров fuels



Check of system of catching паров fuels

Fig. 2.223. Scheme of check of system of catching паров fuels



Disconnect a vacuum hose from the case of a butterfly valve and connect to a vacuum hose the manual vacuum pump.
Check depression on the specified power setting, when the engine cold (temperature of cooling liquid of 60 °C or below) and when the engine is heated-up (temperature of cooling liquid of 80 °C or above).

Adsorber check
Check pipelines of system of catching паров fuels on absence of weakening of connections, sharp excesses or damage.
Check absence of deformation, cracks and leakages of fuel.

Fig. 2.224. Adsorber


After removal of an adsorber check it on lack of cracks and deformation (fig. 2.224).
Check of the electromagnetic valve of a purge of an adsorber

NOTE
At a detachment of vacuum hoses always previously put adjusting labels that at connection hoses were established in a starting position.

Disconnect a vacuum hose from the electromagnetic valve of a purge of an adsorber.
Disconnect the socket of a plait of wires from the electromagnetic valve.
Connect the manual vacuum pump to the union of the electromagnetic valve from which the hose with a red strip was disconnected.



Fig. 2.225. The check scheme at a food connection / detachment from the storage battery to conclusions of the electromagnetic valve


Create depression and check operation of the valve at a food connection / detachment from the storage battery to conclusions of the electromagnetic valve (fig. 2.225).

Fig. 2.226. Resistance measurement between conclusions of the electromagnetic valve


Measure resistance between conclusions of the electromagnetic valve (fig. 2.226).
Electromagnetic valve of a purge of an adsorber: resistance of a winding – 26 Ohm (at temperature of 20 °C).

«previous page
2.7.4. System of compulsory ventilation of a case
following page»
2.7.6. System of supply of fuel