Hyundai Matrix service from 2002 to 2006 of release
1. Operation and car maintenance
2. Engine
2.1. Maintenance
2.2. Mechanical part (engine of 1,6 l)
2.2.1. Check of the block of cylinders
2.2.2. Removal and installation of a support of the power unit
2.2.3. Removal and engine and transmission installation assembled
2.2.4. Removal, check and installation of camshafts
2.2.5. Removal, check and installation of a belt of a drive of the mechanism of a gazoraspredeleniye
2.2.6. Dismantling, check and assembly of a cranked shaft
2.2.7. Removal, check and installation of a flywheel (MKPP) or plate of a drive of the hydrotransformer (AKPP)
2.2.8. Dismantling and assembly of shatunno-piston group
2.3. Mechanical part (engine of 1.8 l)
2.4. Cooling system
2.5. Greasing system
2.6. Power supply system
2.7. Control system, fuel system and system of decrease in toxicity
2.8. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 









2-2-7-snyatie-proverka-i-ustanovka-makhovika-mkpp-ili-plastiny.html

2.2.7. Removal, check and installation of a flywheel (MKPP) or plate of a drive of the hydrotransformer (AKPP)

Removal
Remove a transmission and coupling.
Remove a flywheel.

Fig. 2.70. Flywheel and plate of a drive of the hydrotransformer



Check
Check a condition of a surface of contact of a flywheel with a conducted disk of coupling (lack of non-uniform wear or damage). Replace a flywheel if the surface is damaged or has considerable wear.
Measure palpation of a surface of contact of a flywheel with a conducted disk of coupling.
Nominal rate of palpation of a flywheel: 0,1 mm.
Check a condition of a gear wreath of a flywheel (absence of damages, cracks and considerable wear) and replace it if necessary.

Installation
Establish a flywheel in collecting and tighten bolts of fastening the nominal moment of an inhaling.
Moment of an inhaling of a bolt of fastening of a flywheel: 120–130 N · m.

«previous page
2.2.6. Dismantling, check and assembly of a cranked shaft
following page»
2.2.8. Dismantling and assembly of shatunno-piston group