Hyundai Matrix service from 2002 to 2006 of release
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.1.1. Check and adjustment of a pedal of a brake
6.1.2. Check of operation of the vacuum amplifier of brakes without a tester
6.1.3. Air removal from a hydraulic actuator of brakes
6.1.4. Check and adjustment of a course of the lever of the parking brake
6.1.5. Removal and installation of the vacuum amplifier of brakes
6.1.6. Check of highways of brake system
6.1.7. Removal and installation of a pedal of a brake
6.1.8. Removal, check and installation of forward brake shoes
6.1.9. Dismantling, check and assembly of a brake support
6.1.10. Dismantling, check, assembly and installation of the main brake cylinder
6.1.11. Regulator of pressure of back brakes
6.1.12. Removal, check and installation of back drum-type brakes
6.1.13. Replacement of the working brake cylinder
6.1.14. Removal, check and installation of the parking brake
6.1.15. Anti-blocking system of brakes (ABS)
6.1.16. Removal and installation of the electronic ABS control unit
6.1.17. Removal and check of sensors of frequency of rotation of a wheel (ABS)
6.2. Tables
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 









6-1-4-proverka-i-regulirovka-khoda-rychaga-stoyanochnogo-tormoza.html

6.1.4. Check and adjustment of a course of the lever of the parking brake

Lift the lever of the parking brake with effort about 196 N and count up number of clicks.
Course of the lever of the parking brake - 8 clicks.

Fig. 6.8. Adjusting nut


If the size of a course of the lever of the parking brake (number of clicks) does not correspond to nominal rate, adjust a lever course rotation of an adjusting nut on the equalizer of a cable of a drive of the parking brake (fig. 6.8).
The control lamp of brake system dies away at completely lowered lever of the parking brake and lights up at a lever raising on one tooth of a ratchet (click). If work of a control lamp differs from specified, replace a lamp.
After adjustment check lack of a prikhvatyvaniye of back brakes at completely lowered lever of the parking brake.

«previous page
6.1.3. Air removal from a hydraulic actuator of brakes
following page»
6.1.5. Removal and installation of the vacuum amplifier of brakes