1.6.1. Adjustable seats

ATTENTION Make seat adjustment only on the motionless car. Non-compliance with this rule can lead to control loss over the car and to a road accident (failure).

Fig. 1.88. Adjustment of longitudinal provision of a forward seat

To move a seat in longitudinal situation, lift the adjustment lever up. Thus the seat will be released, and it can be moved forward and back to convenient situation. After installation release the lever of adjustment and slightly move a seat forward or back to fix it in new situation.

Fig. 1.89. Adjustment of an inclination of a back of a seat

For an inclination of a back of a seat bend forward to remove the weight from a back of a seat and pull the lever of adjustment of an inclination of a back of a seat located from the outer side of a seat, up. Press a back of a seat and establish it in desirable situation. to fix a seat back in new situation, release the lever of adjustment of its back.

ATTENTION To reduce risk of emergence of a trauma at a road accident (failure) or sharp braking at movement of the car, backs of seats of the driver and the forward passenger should be in the situation whenever possible close to the vertical. Efficiency of protection of seat belts and inflatable safety cushions can be considerably lowered, when the back of a seat is inclined. There is a high probability of that when the back of a seat is inclined, the driver and the forward passenger can slip out from under a seat belt that will entail receiving serious traumas at car collision during a road accident (failure). The seat belt cannot provide complete protection of the passenger when the back of his seat is inclined.

Fig. 1.90. Head restraint adjustment

Head restraints provide protection of area of a neck.

To lift a head restraint, pull it up. to lower a head restraint, press it down, at the same time pressing a clamp.

Fig. 1.91. Adjustment of a lumbar podpor

For adjustment of a lumbar podpor turn the special lever located on the outer or left side of a back of a seat of the driver. For increase in force of support move the lever of adjustment of a lumbar podpor towards a forward part of the car. For easing of force of support move the lever towards a back part of the car.

Fig. 1.92. Adjustment of height of a pillow of a seat

To lift or lower a forward part of a pillow of a seat, turn the forward handle forward or back. To lift or lower a back part of a pillow of a seat, turn the back handle forward or back.

Fig. 1.93. A tray under a seat of the forward passenger

Under a seat of the forward passenger there is a tray (fig. 1.93).

That it to open, pull it forward.

Fig. 1.94. Adjustment of longitudinal provision of a back seat

To move a seat in longitudinal situation, lift the adjustment lever up. Thus the seat to be released and it can be moved forward and back to necessary situation. After installation in convenient situation release the lever of adjustment and slightly move a seat forward or back to fix it in new situation.

Fig. 1.95. Adjustment of longitudinal provision of a back seat

For an inclination of a back of a seat pull the lever of adjustment of an inclination of a back of a seat towards a head restraint and after back installation in desirable situation release the lever. After installation of a back of sitting in desirable situation always check reliability of its fixing.

Fig. 1.96. Adjustment of head restraints of back seats

To lift a head restraint, pull it up. to lower a head restraint, press it down, at the same time pressing a clamp.

Fig. 1.97. Folding of a pillow and back of a back seat

For convenience the back and a pillow of back sitting can be combined and spread out.

To combine a seat back, move it to extreme back situation.

Remove head restraints.

To combine a seat back, pull and hold the lever of adjustment of an inclination of a back of a seat towards a head restraint, and then lower a seat back down.

Fig. 1.98. Raising of a pillow and back of a back seat

Pull the lever of an unblocking of a pillow of a seat up, and then lift a pillow of a back seat up (fig. 1.98).

ATTENTION For prevention of damage of a coaster of the back seat located in the back console, at first clean it, and then combine a back and a pillow of a back seat.

Fig. 1.99. Seat fixing

For fixing of a seat fasten a loop for the fastening, located under a seat pillow, to the holder of a head restraint of a seat of the driver and the forward passenger (fig. 1.99).

Insert the removed head restraints between a back and a pillow of a back seat so that. they were not thrown out in car salon in case of sharp braking or failure.

For return of a back and a pillow of a back seat to normal situation repeat the above-stated operations upside-down.

After return of a back of a seat to vertical situation be convinced that it is reliably fixed, shaking a seat back forward and back for its top part.

ATTENTION At return of a back of a back seat to vertical situation after the seat was combined, be careful, do not damage a tape or the seat belt lock. Besides, do not allow a jamming of a tape or a seat belt uvula a back seat. The pillow of back sitting developing forward and back of back sitting inclined forward are intended to transport bigger volume of luggage in the car. Do not allow anybody to sit on luggage during car movement. When the back of a back seat is combined use of seat belts is impossible. Incorrectly sitting and not fastened passengers can get heavy and even deadly traumas in case of sharp braking or a road accident. The transported luggage should not settle down above backs of forward seats. It can lead to luggage shift forward and to drawing of heavy traumas in case of sharp braking or a road accident (failure). At return of a back of a back seat to vertical situation after the seat was combined, be convinced that head restraints are correctly fixed. Head restraints are important for safety of passengers of the car in case of a road accident (failure). If head restraints are not established in the correct situation, at arrival receiving serious or even deadly traumas is behind possible.

Fig. 1.100. Switches of heating of forward seats

For trips to cold weather in the car there is a heating of forward seats. When the engine works, press any of switches of heating of seats of the driver or the passenger. At moderate weather or in conditions, when there is no need for heating of seats, switches of heating of seats should be in the situation "OFF" ("Off").

Do not hold the lighter in completely drowned situation. It can lead to damage of a heating element and ignition. In case of need lighter replacements, use only the original lighter or similar.

Fig. 1.101. Lobbies and back ashtrays

To open a forward ashtray, press also otpustitey the upper edge.

To take out an ashtray from a nest for cleaning, it is necessary to remove the metal collection of ashes. Press the ashes collection down and forward in an ashtray then take out it. to put it into place, establish the ashes collection in the correct situation and press it down and forward to fix the bottom edge of the collection of ashes in an ashtray. Illumination of an ashtray burns only at inclusion of external illumination of the car.

Fig. 1.102. Forward coasters

The coaster serves for keeping of glasses and bottles in available openings.

To use a coaster for the forward passenger press a coaster and pull out outside.

ATTENTION Do not place extraneous subjects on a coaster. They can be thrown out in salon of the car and injure passengers of the car at sharp braking or in case of a road accident (failure).

Fig. 1.103. Back coasters

The back coaster is located on the back main console and serves for keeping of glasses and bottles in available openings. to use, press the handle on the back main console down and pull out it for the upper edge.

ATTENTION For prevention of damage of a coaster of the back seat located in the back console, at first clean it, and then combine a back and a pillow of a back seat. Return a coaster to a starting position if it do not use.

Fig. 1.104. Central armrest of a back seat

This armrest is located in the center of a back of a back seat and has a ware box. Having opened a cover of a ware box, it is possible to use a coaster available in it.